Trouble-Shooting Procedure; Take Out The F1 Fuse And Check - Haaga 677 Manuel D'utilisation

8.3 Trouble-shooting procedure

CAUTION
Risk of injury from unintentional starting of Risk of injury from unintentional starting of
the sweeping machine. the sweeping machine.
After correcting fault on the sweeping machine After correcting fault on the sweeping machine
there is a danger of items being pulled into the there is a danger of items being pulled into the
machine due to the unintentional starting of machine due to the unintentional starting of
the sweeping machine. the sweeping machine.
• Before the battery is connected ensure • Before the battery is connected ensure
that the position of the on/off switch is in 0 that the position of the on/off switch is in 0
position. position.
1. Set on/off switch on the device to position 0.
2. If necessary, disconnect the blue battery lead.
3. Correct the fault as described in the fault table.
4. If necessary, reconnect the blue battery
connecting lead.
5. Switch the sweeping machine on by switching
the on/off switch to the I position. Check
whether the device is working again as usual.

8.4 Take out the F1 fuse and check

In order to protect the electrical components, the
sweeping machine is fi tted with a 15 amp safety
fuse. In order to check and replace the F1 fuse
proceed as follows:
CAUTION
Danger of injury or accident due to Danger of injury or accident due to
incorrect fuse strength. incorrect fuse strength.
Use of the incorrect fuse strength can lead Use of the incorrect fuse strength can lead
to overload of the electrical components, to overload of the electrical components,
the emission of smoke, or fi re, whether the the emission of smoke, or fi re, whether the
machine is switched off , being charged or in machine is switched off , being charged or in
operation. operation.
• Replace the fuse only with a new 15 amp • Replace the fuse only with a new 15 amp
fuse approved by the manufacturer. fuse approved by the manufacturer.
haaga 677 / 697 / 697 plus
Fig. 18: Remove cover
1. Set on/off switch on the device to position 0.
CAUTION
Risk of injury from unintentional starting of Risk of injury from unintentional starting of
the sweeping machine. the sweeping machine.
When working on the sweeping machine there When working on the sweeping machine there
is a danger of items being pulled into the is a danger of items being pulled into the
machine due to the unintentional starting of machine due to the unintentional starting of
the sweeping machine. the sweeping machine.
• Ensure that the device is not switched on by • Ensure that the device is not switched on by
accident while the fuse is being taken out accident while the fuse is being taken out
and checked. If necessary, disconnect the and checked. If necessary, disconnect the
blue battery connecting lead. blue battery connecting lead.
NOTE
Serious damage to the device can be caused Serious damage to the device can be caused
by use of a fuse with a higher or lower by use of a fuse with a higher or lower
strength. strength.
In order to avoid damage, replace a blown In order to avoid damage, replace a blown
fuse only with a 15 amp fuse approved by the fuse only with a 15 amp fuse approved by the
manufacturer. Only replace the fuse when the manufacturer. Only replace the fuse when the
cause of the fault has been dealt with. cause of the fault has been dealt with.
1
Troubleshooting
2
EN
55