Set Hold-Down Device; Battery Operation And Led Display - Haaga 677 Manuel D'utilisation

7.3 Set hold-down device

With the hold-down device, the right plate broom
is adjusted to the edge regions to be swept, for
example on walls or curbs.
NOTE
An unsuitable setting of the hold-down device An unsuitable setting of the hold-down device
at lower edges can lead to excessive wear. at lower edges can lead to excessive wear.
The hold-down device must not scratch on the The hold-down device must not scratch on the
ground. ground.
1
Fig. 14: Hold-down device setting
Sweeping out edges and corners
• Press down the handle (1) of the hold-down
device.
Operation on surfaces
• Pull up the handle of the hold-down (1) device.
haaga 677 / 697 / 697 plus

7.4 Battery operation and LED display

Fig. 15: Use and display
The LED display (2) communicates the operating
state of the battery-operated sweeping machine.
• Place the sweeping machine on the surface to
• Switch on the sweeping machine by switching
The plate brooms and fi ne sweeping rolls begin
to rotate. The LED display (2) will show green
during battery operation provided there is
suffi cient charge.
1
be swept.
CAUTION
Do not operate the on/off switch with your Do not operate the on/off switch with your
foot. foot.
This may cause injury by causing you to fall This may cause injury by causing you to fall
or stumble when the plate brooms on the or stumble when the plate brooms on the
sweeping machine begin to move. sweeping machine begin to move.
• Only switch the machine on by hand. • Only switch the machine on by hand.
the on/off switch (1) to position I.
Operation
EN
2
49