Troubleshooting - Haaga 677 Manuel D'utilisation

Troubleshooting

8. Troubleshooting
WARNING
Risk of cutting due to broken glass, metal Risk of cutting due to broken glass, metal
or other sharp edged materials! or other sharp edged materials!
EN
When emptying the sweeping container, When emptying the sweeping container,
cutting injuries may occur due to broken glass, cutting injuries may occur due to broken glass,
metal or other sharp edged materials. metal or other sharp edged materials.
• Wear the prescribed personal protective • Wear the prescribed personal protective
equipment! equipment!
CAUTION
Health impairments caused by dust Health impairments caused by dust
resulting from sweeping! resulting from sweeping!
The inhalation of dusts can endanger the The inhalation of dusts can endanger the
health. health.
• Wear the prescribed personal protective • Wear the prescribed personal protective
equipment! equipment!
CAUTION
Risk of injury through tipping over of the Risk of injury through tipping over of the
push bar! push bar!
Tipping over of the push bar may lead to slight Tipping over of the push bar may lead to slight
injuries, such as jamming of the fi nger or injuries, such as jamming of the fi nger or
bruising in users or other persons. bruising in users or other persons.
• When carrying the device, hold it so that the • When carrying the device, hold it so that the
push bar cannot tip over. push bar cannot tip over.
CAUTION
Risk of injury from unintentional starting of Risk of injury from unintentional starting of
the sweeping machine. the sweeping machine.
When working on the sweeping machine there When working on the sweeping machine there
is a danger of items being pulled into the is a danger of items being pulled into the
machine due to the unintentional starting of machine due to the unintentional starting of
the sweeping machine. the sweeping machine.
• Ensure that the device is not switched on by • Ensure that the device is not switched on by
accident while the fault is being dealt with. If accident while the fault is being dealt with. If
necessary, disconnect the blue battery lead. necessary, disconnect the blue battery lead.
See Section "Disconnect battery leads" in See Section "Disconnect battery leads" in
Chapter 10.2 of this operating manual. Chapter 10.2 of this operating manual.
52
haaga 677 / 697 / 697 plus
Faults may occur even if the prescribed
maintenance work and checks of the device
before use are complied with. Possible faults
are listed in the tables 1 and 2 below, with
specifi cation of the cause and remedy.