TEXTILE PARTS
CLEANING THE INTERIOR
The interior textile parts are washable; it is
important to strictly follow the instructions
below to avoid damaging them:
The cheek pads and head section must be
hand washed in warm, soapy water (about
30°). Do not use aggressive detergents but
either a product for delicate materials in low
dilution or household soap.
It is essential to dry textile and foam parts
completely before reinstalling them in the
helmet. They must be air dried at room
temperature. Never use a clothes dryer or
other heat source. Never iron textile parts.
For parts with a leather appearance or
textiles attached to safety elements, use a
slightly damp sponge or cloth and household
soap and rinse with clean water. Do not
allow too much water to come into contact
with polystyrene parts.
You must insure that all interior parts are
perfectly dry before using the helmet.
WARNING! Damaged interior padding
will compromise the fit of your helmet on
your head and could allow the helmet to come
off your head in an accident, resulting in a head
injury or death.
8
THE TEXTILE PARTS
The textile and foam parts providing
comfort to the Citycruiser make it easy for
you to appreciate the performance of your
helmet to the full.
The parts in contact with the skin are
made in a fabric that is guaranteed to feel
pleasant, to absorb perspiration well and
to resist wear satisfactorily.
We treat surfaces to limit the risk of mould
and bacteria.
WARNING! Although they are selec-
ted for their quality of resistance and
satisfactory wear, all the comfort padding is
subject to normal wear and tear. The rate
of wear and tear will depend on use, care
and maintenance, the length of use and the
degree of acidity of your perspiration. Wear
and tear of the comfort padding will even-
tually change the fit of your helmet on your
head. If that occurs, you must immediately
replace the helmet or padding. See your
retailer for advice.
WARNING! Each time you put on
your helmet, check the fit as dis-
cussed in "Choose your size".