Inspections And Maintenance By Dealer - Stihl FS 510 C Notice D'emploi

English
Thoroughly clean the clamp area of
N
the handlebar with the cloth and
cleaning solution.
Line up the handlebar and secure it
N
in position with the wing screw.
Handlebar cannot be clamped firmly in
position
Release handlebar in clamp as
N
described under "Handlebar is
difficult to move".
Degrease clamp area on handlebar
N
and in clamp moldings.
Line up the handlebar and secure it
N
in position with the wing screw.
42
Inspections and Maintenance
by Dealer
Maintenance Work
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
Fuel Pickup Body in Tank
Check the pickup body in the fuel
N
tank every year and have it replaced
if necessary.
The pickup body should be positioned in
the area of the tank shown in the
illustration.
Spark arrestor in muffler and spacer
2
If the engine is down on power,
N
have the spark arrestor in the
muffler checked.
Check spacer (2) for damage.
N
Have damaged spacer (2) replaced
N
immediately.
Antivibration elements
Four antivibration elements (arrows) are
installed between the powerhead and
the drive tube. Have the system checked
if there is a noticeable increase in
vibrations.
Both vibration gaps (arrows) are preset
to the same width at the factory. If the
size of the two vibration gaps varies
greatly and/or one of them closes up,
have your servicing dealer repair the
antivibration system.
FS 510 C, FS 560 C