Agri-Fab PRO Notice D'utilisation page 6

13. Insert a garden hose gasket into the swivel nut on the
bypass/return hose. Screw the nut onto the upper outlet
of the "Y" valve fitting. Place the other end of the hose
down through the hole at the rear of the tank. See figure
8.
14. Insert a garden hose gasket into the swivel nut on the
boom connecting hose. Screw the nut onto the lower
outlet of the "Y" valve fitting. See figure 8.
15. Slide the coiled hose clamp onto the spray gun hose.
Push the hose onto the hose adapter on the side of
the "T" fitting as shown in figure 8. Tighten the clamp
around the hose and the adapter. Snap the spray gun
into the clips on the side of the tank.
16. Carefully screw the pressure gauge into the top of the
"T" fitting. See figure 8.
BYPASS/RETURN HOSE
SPRAY
COILED
GUN
HOSE
HOSE
CLAMP
BOOM CONNECTING HOSE
FIGure 8
enGlIsH
GARDEN
HOSE
GASKET
PRESSURE
GAUGE
17. Attach the sprayer to the tractor hitch and connect
the wiring to the tractor battery. The red wire must
be connected to the positive post on the battery or to
the "HOT" connection on a tractor switch or ammeter.
The brown wire may be grounded or connected to the
negative battery post. See figures 9 and 10.
ImPorTanT: This sprayer should be connected to 12
volt batteries only!
IN LINE SWITCH
RED
BROWN
FIGure 9
DanGer! Never allow negative pin on plug
to come in contact with positive "hot" post
on battery. Fire or explosion may result!
PLUG
NEGATIVE PIN
FIGure 10
6
QUICK COUPLER
RED
BATTERY
BROWN
POSITIVE
+
"HOT"
POST
NEGATIVE
POST
12 VOLT TRACTOR BATTERY
+