Publicité
Les langues disponibles
Les langues disponibles
assemBlY InsTruCTIons
Tools reQuIreD For assemBlY
(2) 1/2" Wrenches
(1) Screwdriver
(1) Pliers
1. Remove all items from carton and lay out as shown on
pages 2 and 3.
2. Assemble the axle clamps and four 5/16" SEMS nuts
to the factory installed bolts in the frame tubes. Do not
tighten yet. See figure 1.
FACTORY
INSTALLED
BOLT
AXLE
CLAMP
FIGure 1
3. Slide the axle through the two axle clamps. See figure
2.
4. Assemble a spacer, a 3/4" washer, a wheel (valve
stem facing out) and another 3/4" washer onto the
axle. Assemble a cotter pin through the end of the axle.
Repeat on other end. See figure 2.
5. Tighten the four nuts which fasten the axle clamps to
the frame tubes. Refer back to figure 1.
1/8" x 1-1/2"
COTTER PIN
FIGure 2
5/16" SEMS NUT
SPACER
3/4" WASHER
enGlIsH
6. Assemble a hitch arm to the inside of a frame tube
underneath the tank. Use two 5/16" x 2" hex bolts and
5/16" nylock nuts as shown in figure 3. Do not tighten
yet. Repeat for other side.
FIGure 3
7. Fasten the ends of the hitch arms together using two
5/16" x 1-1/4" hex bolts and 5/16" nylock nuts. Do not
tighten yet. See figure 4.
8. Assemble the hitch brackets to the hitch arms using
two 5/16" x 2" hex bolts and 5/16" nylock nuts. Position
each bolt behind a cross bolt in the hitch arms. Do not
tighten yet. See figure 4.
5/16" x 1-1/4"
HEX BOLT
5/16" NYLOCK NUT
FIGure 4
9. Tighten all bolts starting with the bolts in figure 3, then
the bolts in figure 4.
4
5/16" NYLOCK NUT
5/16" x 2"
HEX BOLT
HITCH ARM
5/16" x 2"
5/16" NYLOCK NUT
HEX BOLT
Publicité
