Publicité
Les langues disponibles
Les langues disponibles
10. Assemble the boom mount bracket to the rear of the
frame tubes using two 5/16" x 2" hex bolts and 5/16"
nylock nuts. See figure 5.
5/16" x 2"
HEX BOLT
FIGure 5
11. Assemble the boom bars to the boom mount bracket
using two 5/16" x 1-1/4" carriage bolts, tooth lock washers
(between the bar and bracket), 5/16" flat washers and
knobs. T he boom connecting hose should extend upward.
See figure 6.
noTe: Make sure the nozzles are adjusted so that the
openings face straight down when the boom bar is in the
horizontal operating position.
BOOM CONNECTING HOSE
5/16" FLAT
WASHER
KNOB
BOOM BAR
CARRIAGE BOLT
5/16" x 1-1/4"
FIGure 6
5/16" NYLOCK NUT
rear VIew
WASHER
(TOOTH LOCK)
enGlIsH
12. Assemble the large and small spray gun clips to the
side of the tank using two #10 x 3/8" screws and #10
lock washers. See figure 7.
#10 x 3/8"
SCREW
#10 LOCK
WASHER
FIGure 7
5
SPRAY GUN
SPRAY GUN
CLIP (LARGE)
CLIP (SMALL)
Publicité
