Getting Started; Preparing The Unit And The Remote Control; Connecting To An Ac Power Source; Preparing The Remote Control - Sony RDP-XA900iPN Mode D'emploi

Getting Started

Preparing the Unit and
the Remote Control
Connecting to an AC power
source
1
Plug the connector of the AC
power cord into the AC IN
terminal on the unit.
2
Plug the AC power cord to a
wall outlet (the mains).

Preparing the remote control

Before using the remote control for the first
time, remove the insulation film.
10
GB
To replace the battery of the
remote control
If the remote control stops working, replace
the battery (CR2025) with a new one.
the e side facing up

Turning on the unit

Press the ?/1 button
The ?/1 indicator starts flashing. You can
operate the unit when the ?/1 indicator stops
flashing and lights up green.
The LINK indicator also starts flashing. You
can set up or use the "AirPlay" function when
it stops flashing.
It may take a while for these indicators to stop
flashing.
Note
After playback of the connected device has finished,
if no operation is performed for about 20 minutes,
the unit will automatically enter standby/network
standby mode.
j