Cleaning The Brewing Unit - Siemens TI921 Série Mode D'emploi

en Daily care and cleaning
Notes
All parts of the milk system can be
■
cleaned in the dishwasher.
Detergent residues in the milk
system must be thoroughly removed
following the rinsing process.
Important: The outlet system cover
■
is not dishwasher-safe.
Inserting the milk system: ~ Fig. #:
Assemble the individual parts of the
1.
milk system.
Insert the milk system into the cover.
2.
Slide the outlet system to the bottom
3.
position.
Position the cover at the bottom and
4.
pivot it upwards until it engages.

Cleaning the brewing unit

~ Fig. $, ~ Fig. (
In addition to the automatic cleaning
programme, the brewing unit should be
removed regularly for cleaning.
Caution!
Clean the brewing unit without detergent
and do not put it in the dishwasher.
Remove the brewing unit:
Switch the appliance off.
1.
Remove the water tank.
2.
Slide both red locking sliders
3.
towards one another and remove the
cover.
Remove, clean and dry the coffee
4.
grounds slider (red) and the brewing
unit cover (red).
Slide the red lock to the right across
5.
the brewing unit.
58
Carefully remove the brewing unit
6.
and clean thoroughly under running
water.
Clean the interior of the appliance
7.
thoroughly with a damp cloth,
removing any coffee residues.
Allow the brewing unit and the
8.
interior of the appliance to dry.
Insert the brewing unit:
Push the brewing unit into the
1.
appliance in the direction of the
arrow. The arrow is located on top of
the brewing unit.
Position the brewing unit from
above, suspend on the guide rails
and push into the appliance.
Slide the red lock to the left across
2.
the brewing unit.
Insert the coffee grounds slider (red)
3.
and the brewing unit cover (red).
Insert the cover until it engages.
4.
Insert the water tank.
5.