Dispensing Hot Water - Siemens TI90 HC Série Mode D'emploi

Coffee drinks with milk
The appliance is switched on. The water
tank and bean container have been
filled.
The milk container filled with milk is
connected.
Place a cup or a glass under the
1.
outlet system.
Use the rotary selector to select the
2.
desired drink.
The name of the drink and the currently
active values are shown on the display.
To change the settings for the
3.
selected drink
~ "Adjusting beverage settings"
on page 58
To begin dispensing the drink, press
4.
the rotary selector.
The milk is dispensed into the cup or
glass first. The coffee is then brewed
and dispensed into the cup or the glass.
Pressing the rotary selector once
Note:
can prematurely stop the dispensing of
milk or coffee; pressing the rotary
selector twice stops the drink
dispensing completely.
Milk froth or warm milk
The appliance is switched on. The water
tank has been filled.
The milk container filled with milk is
connected.
Place a cup or a glass under the
1.
outlet system.
Select "Milk froth" or "Warm milk"
2.
with the rotary selector.
The name of the drink and the currently
active values are shown on the display.
To change the settings for the
3.
selected drink
~ "Adjusting beverage settings"
on page 58
To begin dispensing the drink, press
4.
the rotary selector.
Operating the appliance en
Milk froth or warm milk is dispensed
into the cup or glass.
To prematurely stop dispensing
Note:
the drink, press the rotary selector
again.

Dispensing hot water

Before dispensing hot water,
Note:
clean the milk system and remove the
milk container. If the milk system is not
cleaned, the dispensed water may
contain small quantities of milk.
~ "Cleaning the milk system"
on page 72
:
Warning
Risk of burns!
The outlet system becomes very hot.
After use, always let the outlet system
cool down before you touch it.
The appliance is switched on. The water
tank has been filled.
Place a cup under the outlet system.
1.
Remove the milk container, if
2.
connected.
Select "Hot water" with the rotary
3.
selector.
To change the settings for the
4.
selected drink
~ "Adjusting beverage settings"
on page 58
To begin dispensing the drink, press
5.
the rotary selector.
Hot water is dispensed into the cup.
To prematurely stop dispensing
Note:
the drink, press the rotary selector
again.
57