switel WTF737 Mode D'emploi page 60

Operating the Walkie−Talkies
Scanning for a channel
If an active channel is detected, the channel scan stops.
Press the P button to enable radio communication on this channel.
S
If you do not press the P button, channel scanning is resumed five
S
seconds after no further signal has been transmitted on this channel.
Press the X/Y button to skip this channel.
S
Start / End channel search
5x M X/Y
The scanning routine stops at every channel on which a signal is received regardless
of the CTCSS/DCS code transmitted with the signal.
6x M X/Y
The scanning process stops when a signal with a CTCSS code is transmitted on the
set channel.
7x M X/Y
The scanning process stops when a signal with a DCS code is transmitted on the set
channel.
P
Transmitting the ringing tone
The ringing tones indicate to other subscribers that you want to talk to them. A condi-
tion for this is that the other subscribers are using the same channel and CTCSS
code.
C
Selecting/Deactivating ringing tones
There are 15 ringing tones available for selection.
8 x M
X/Y, P
Call alert / Vibration alert
9x M X/Y
X/Y, P
60
Start channel scanning
Start channel scanning with CTCSS
Start channel scanning with DCS
End channel scanning
Send the ringing tone
Activate programming mode
Select ringing tone and confirm it
Call alert / Vibration alert or both indicating an
incoming call
Select the call alert type and confirm it