Makita DVC665 Mode D'emploi page 22

3. To install the filter, insert the side without the
hooks into the groove then push in the filter until the
hooks are secured with a click.
► 1. Groove 2. HEPA filter 3. Hook
Cleaning the dust bag
Regularly clean the dust bag with soap and water. Turn
the dust bag inside out and remove the sticky dust.
Wash lightly by hand and rinse well with water. Dry
completely before installing to the vacuum cleaner.
NOTICE:
Wet dust bag lowers the vacuuming per-
formance as well as the life of the motor.
Cleaning the room for filter bag/
dust bag
2
When cleaning the room for filter bag/dust bag, remove
and wipe the board inside.
3
1
► 1. Board
Removing the board
1. Remove the HEPA filter. Refer to the section for
cleaning the HEPA filter for how to remove.
2. Push down the board, and slide it to left until the
board touches the wall.
3. Lift the right side of the board up and take it out.
► 1. Board
22 ENGLISH
1
1