Specifications; Mounting Precautions (For Sharp Dealers And Service Engineers) - Sharp PN-M501 Manuel D'installation

Model
Power requirement
Operating temperature *
Operating humidity
Power consumption
Dimensions
(excluding protrusions)
Weight
* When using this monitor laying flat on a surface (when the monitor is tilted more than 20 degrees upward or downward from the perpendicular
in relation to a level surface), use this monitor at the ambient temperature between 32°F (0°C) and 86°F (30°C).
Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such
cases, please check the temperature condition specified by the optional equipments.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.

Mounting Precautions (For SHARP dealers and service engineers)

• When installing, removing or moving the monitor, ensure that this is carried out by at least 2 people.
• Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials
such as plaster / thin plastic board / wood before starting installation.
• This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor.
Install by the most suitable method for the material and the structure.
• To attach a VESA-compliant mounting bracket, use M6 screws that are 5/16 inch (8 mm) to 3/8 inch (10 mm) longer than the
thickness of the mounting bracket.
• Do not use an impact driver.
• When moving the monitor, be sure to hold the parts marked by
product damage, failure, or injury.
• After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.
• Do not use any screw holes other than VESA holes for installation.
• When using this monitor laying flat on a surface (when the monitor is tilted more than 20 degrees upward or downward
from the perpendicular in relation to a level surface), consult an authorized SHARP dealer because there are some specific
mounting conditions.
8
E

Specifications

PN-M501
AC 100 - 240 V, 1.4 A, 50/60 Hz
32°F to 104°F (0°C to 40°C)
20% to 80% (no condensation)
120 W
inch (mm) Approx. 44-3/16 (W) x 2-11/16 (D) x
25-1/2 (H) (1123 x 68 x 647)
lbs. (kg) Approx. 49 (22)
5/16 - 3/8 inch (8-10 mm)
PN-B501 PN-M401
AC 100 - 240 V, 1.1 A, 50/60 Hz
92 W
Approx. 35-1/2 (W) x 2-5/8 (D) x 20-3/16 (H)
(902 x 66 x 513)
Approx. 34 (15)
Screws (M6)
Mounting bracket
Monitor mounting
below. Do not hold the LCD panel. This may cause
PN-B401