Operation; Control Panel Overview; Weekly Timer; Setting The Weekly Timer - Pentair PROWLER 930 Guide D'installation

6

Control Panel Overview

Bluetooth® Wireless Technology

Weekly Timer

The power supply has a timer control that allows you to set an automatic cleaning schedule each week. Be sure
the cleaner is fully immersed in water before turning on the power.

Setting the Weekly Timer

When the power supply is switched on, you may choose a
pool cleaning schedule for the coming week by pressing
the Weekly Timer button.
Note: The cleaner will always begin to work upon set-up.
Schedule LEDS:
LED 1 - The cleaner will automatically work every
day for a full cycle = 7 times per week. Press
the Weekly Timer button once to select this
interval.
LED 2 - The cleaner will automatically work every other
day for a full cycle = 3 times per week. Press
the Weekly Timer button twice to select this
interval.
LED 3 - The cleaner will automatically work every 3
days = 2 times a week. Press the Weekly Timer
button three times to select this interval.
Pressing the Weekly Timer button four consecutive
times will reset the cleaner' s schedule. If you do not
press any of the buttons within the first 5 seconds after
the power has been switched on, the cleaner will default
to running one cycle only.
While the cleaner is working in weekly timer mode, the
appropriate Weekly Timer LED will blink constantly
between cycles. At the end of the week the power supply
automatically shuts off.
PROWLER™ 930 Robotic Inground Pool Cleaner Installation and User' s Guide

OPERATION

Connection Indicator
Weekly Schedule
ON/OFF
Button
3 Schedule 2 Cleaning
LEDs Speed LEDs
Cleaning Speed
Button Button

Cleaning Speed (Quick Clean Feature)

The Prowler™ 930 Pool Cleaner can be set to clean your
pool at either its standard cleaning speed or at a higher
cleaning speed referred to as Quick Clean.
1. The cleaner' s default speed is symbolized by the
icon on the power supply. When the cleaner is
performing a default cleaning cycle the LED under
this icon will illuminate.
2. Quick Clean is symbolized by the
power supply. When the cleaner is performing a
Quick Clean cleaning cycle the LED under this icon
will illuminate.
To begin a Quick Clean cycle, press the Cleaning
Speed button once. The cleaner will immediately
enter Quick Clean mode and will clean the pool for
one hour.
Note: While in Quick Clean mode the cleaner will only
clean the pool floor. The cleaner will NOT climb and clean
pool walls.
Note: Once Quick Clean is selected, the cleaner will
continue to clean in Quick Clean mode each time the
cleaner is activated. To return to the default cleaning
cycle the Cleaning Speed button must be pressed while
the cleaner is active.
icon on the