Operation; Setting The Weekly Timer - Pentair Prowler 920 Guide D'installation

4
Weekly Timer
The power supply has a timer control that allows you to set an automatic cleaning schedule each week. Be sure
the cleaner is fully immersed in water before turning on the power.

Setting the Weekly Timer

When the power supply is switched on, you may choose a
pool cleaning schedule for the coming week by pressing
the Weekly Timer button.
Note: The cleaner will always begin to work upon set-up.
ON/OFF
Button
Pressing the Weekly Timer button four consecutive times will reset the cleaner' s schedule. If you do not press any
of the buttons within the first 5 seconds after the power has been switched on, the cleaner will default to running
one cycle only.
While the cleaner is working in weekly timer mode, the appropriate Weekly Timer LED will blink constantly between
cycles. At the end of the week the power supply automatically shuts off.
PROWLER™ 920 Robotic Inground Pool Cleaner Installation and User' s Guide

OPERATION

3 Schedule
LEDs
Weekly Schedule
Button
Schedule LEDS:
LED 1 - The cleaner will automatically work every
day for a full cycle = 7 times per week. Press
the Weekly Timer button once to select this
interval.
LED 2 - The cleaner will automatically work every other
day for a full cycle = 3 times per week. Press
the Weekly Timer button twice to select this
interval.
LED 3 - The cleaner will automatically work every 3
days = 2 times a week. Press the Weekly Timer
button three times to select this interval.