Pentair PROWLER 930 Guide D'installation page 7

PREPARATION OF THE POOL AND CLEANER
STEP 3:
Connect Power Supply to Cleaner
Connect the communication cable to the power supply.
Ensure the connector notch is lined up with the
corresponding groove in the socket on the power supply.
Turn the cable connector clockwise to lock the cable
into the power supply connection. See Figure 3.
STEP 4:
Figure 3
Connect Power Supply to Power Source
Connect the power supply to the electrical source/outlet.
See Figure 4.
RISK OF ELECTRICAL SHOCK OR
ELECTROCUTION: Connect only to a
grounding type receptacle protected by a earth leakage
circuit breaker 30mA. Contact a qualified electrician if
you cannot verify that the receptacle is protected by a
earth leakage circuit breaker 30mA.
To reduce the risk of electrical shock,
do not use extension cord to connect
unit to electrical supply; provide a properly located outlet.
Figure 4
STEP 5:
Placing the Cleaner in the Pool
Operating the cleaner out of water will immediately
cause severe damage and will result in loss of warranty.
Do not leave the cleaner in the pool all the time. Always
remember to turn the power supply "OFF" and unplug
it from the power outlet before removing the cleaner
from the pool.
1. Be sure the power supply is positioned at least 3.5 m
from the pool.
2. Lower the cleaner into the pool by the handle. see
Figure 5.
Note: Never lower the cleaner into the pool by the
communication cable. This puts an unnecessary
strain on the cable and could result in damage to
the cleaner.
3. Gently tilt the cleaner from side to side or turn
upside down to release trapped air. See Figure 6.
PROWLER™ 930 Robotic Inground Pool Cleaner Installation and User' s Guide
Do not switch the pool cleaner to "ON"
if it is not fully immersed in water.
Figura 5
3
Figura 6