Periodic Filter Screen Cleaning - Pentair PROWLER 930 Guide D'installation

10

Periodic Filter Screen Cleaning

Note: It is recommended that you clean the filter screens at least once a month. Too much debris in the filter
screens will restrict the suction power of the Prowler™ 930 Robotic Pool Cleaner and reduce its effectiveness.
To dismantle and clean the four filter screens, follow the instructions given below.
STEP 1:
Empty the Inner and Outer Filter Baskets.
Follow steps 1-5 on the previous page. The inner and
outer filter baskets should be emptied and rinsed clean
before removing the outer basket' s filter screens.
STEP 2:
Remove the Filter Screen
Using your thumbs, firmly press inwards on the top of
Panel 1 to remove the filter screen from its frame.
See Figure 25.
Each filter screen is stamped with a number. see Figure 26.
Remove the filter screens in numerical order:
Screen 1 > 2 > 3 > 4.
Figure 25
Figure 26
PROWLER™ 930 Robotic Inground Pool Cleaner Installation and User' s Guide
MAINTENANCE
STEP 3:
Clean the Filter Screens
Thoroughly clean the filter screen with a garden hose.
See Figure 27.
STEP 4:
Reassemble the Filter Screens
Replace the filter screens by seating the bottom of the
screen into its frame, then pushing firmly outwards on
the top of the screen until a click is heard.
Each filter screen is stamped with a number. See Figure
28. Replace the filter screens in numerical order:
Screen 4 > 3 > 2 > 1.
Figure 27
Figure 28