EUROM VK2002 Manuel D'utilisation page 15

Keep the heater clean.
17.
a common cause of overheating. Make sure these deposits are removed regularly.
Do not turn on the appliance if you have discovered damage to
18.
the appliance, cord or plug, if the appliance is malfunctioning, if it
has been dropped or if there are signs of any other defect.
the complete product to the vendor or to a certified electrician for inspection and/or
repair. Always ask for original parts. The appliance (incl. cord and plug) may only be
opened and/or repaired by properly authorised and qualified persons. Do not use
attachments and/or accessories, not recommended or supplied by the manufacturer.
Only use this heater for its intended purpose and as described in
19.
this instruction manual.
Not abiding by instructions 18 & 19 may lead to damage, fire and/or personal injuries. A
failure to adhere to these rules also immediately nullifies the guarantee and vendor,
importer and/or manufacturer do not take responsibility for any of the consequences!
Description
1 – control dial
2 – thermostat dial
3 – pilot light
4 – handle
5 – air outlet grill
6 – air intake grill (reverse side)
Location and Connection

Remove all packaging material and keep out
of reach of children. After removing
packaging, check the appliance for damage
or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do
not use the appliance, but contact your
vendor for inspection or replacement.

Choose a suitable location for the heater which is at least one metre away from any
obstructions, walls or inflammable materials (see also safety instructions).

Make sure a functioning heater is always placed on a solid, flat and horizontal surface.

Check if the control dial is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 230V socket. To prevent the
circuit overloading, check that no other appliances are connected to the same group.
Set-up and Operation

Turn the thermostat dial to maximum (clockwise as far as possible).

Switch the heater on by turning the control dial to one of the following three positions:
Fan only (thermostat always to maximum)
I Heating at half power (1000W)
II Heating at full power (2000W)
Dust, dirt and/or a build up of deposits in the heater are
15
Return