Technical Data; Installation - Zanussi ZBA23020SA Notice D'utilisation

Technical data

Dimension of the recess
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Height
Width
Depth
Ambient temperature
1225 mm
560 mm
550 mm
230-240 V
50 Hz
Door reversibility
The door of the appliance opens to the right. If you want to
open the door to the left, do these steps before you install
the appliance:
1
Loosen the upper pin
and remove the spacer.
2
Remove the upper pin
and the door.
3
Loosen the lower pin.
On the opposite side:
1
Install the lower pin.
2
Install the door.
3
Tighten the spacer and
the upper pin.
27