Melitta bar-cube mc Mode D'emploi page 28

7. Preparation
After the device has been properly set up and
connected according to these instructions, you can
now prepare it for operation:
❍
If cleaning is first required, refer to chapter 8
for details.
❍
If you have previously moved the device, let it
stand still for 2 hours to allow the oil filling to
distribute itself uniformly.
a) Refilling the milk
Use pre-cooled milk - the cooling power is designed
to keep items cool but not to cool down warm milk.
➀
Open the device door and ...
GB
➁
Pull out the milk container by approximately one
third.
➂
Push the cover back and fill the milk into the milk
container.
❍
When closing the cover, check to make sure that
the milk suction hose is immersed in the milk.
You may now push the container in the
refrigerator and close the door.
b) Switching ON / OFF
Behind the opened door you will find the on/off switch
of the appliance.
The appliance should be switched on about an hour
before use so that the refrigerator has cooled down
sufficiently.
➀ ➁
8
➂