Publicité
Les langues disponibles
Les langues disponibles
•
The CST remote control must be handled with care. Do not
drop it or expose it to direct sunlight or sources of heat. It is
advisable to keep the CST remote control placed on a table
or a flat surface. Do not hold the CST remote control in your
hand for long time to avoid altering the reading of the sen-
sors.
•
The CST sensors are also disabled if the CST remote control is
positioned at a distance less than 3.3ft (1 m) from the unit.
•
The CST remote control is equipped with touch sensitive
buttons.
•
The CST remote control is equipped with a dual color LED
(D10) (white/red). White indications are used for:
-
signaling the touching of each button with 3 fast flashes
-
it blinks every 30 seconds for data transmission
-
signaling the entering of pairing phase with periodic
blinking
-
signaling the battery status is "good"
•
The same indications but in red color mean that the batter-
ies are starting to be exhausted.
Please note: The remote control can be safely stored in the ap-
propriate compartment (A11).
TURNING THE APPLIANCE ON/OFF
•
Plug into the outlet.
•
Touch the
ON/STAND-BY button (D1). When turned ON,
the air conditioner starts operating in the same mode as
when it was turned off.
•
Touch the
ON/STAND-BY button (D1) again to switch the
appliance off.
Please note: Never switch the appliance off by removing the plug.
Always switch it off by touching the
and waiting for a few minutes before removing the plug. Only in
this way the appliance will perform its standard checks.
SELECTING THE OPERATING MODES
The operating modes available on the CST remote control
through the MODE button (D2) correspond to those on the ap-
pliance control panel (C).
SELECTING THE TEMPERATURES
In conditioning mode touch button (D3) or (D4) to select
the desired temperature.
SELECTING THE AIR FLOW
In conditioning and fan modes, touch
the desired air flow.
The air flows available are:
Minimum air flow: when room has cooled
down and you want a quieter operation.
Medium air flow: when the noise level needs
ON/STAND-BY button (D1)
button (D7) to select
9
to be low but with a good comfort level.
Maximum air flow: for maximum perfor-
mance.
:
Auto
the appliance automatically chooses the
air flow based on the temperature selected and
the environmental conditions. This selection is
only available in air conditioning mode.
ECO REAL FEEL FUNCTION
ECO REAL FEEL is the innovative De'Longhi technology that works
simultaneously on temperature reduction and humidity control,
securing the best comfort level. With traditional systems, optimal
comfort conditions may be reached but not secured over time.
With ECO REAL FEEL, once optimal comfort is reached, compres-
sor operation and air flow are automatically modulated to keep
it consistent over time and save up to 30% on energy usage.
To activate the function, touch the
control and the ECO REAL FEEL symbol appears.
The"ECO REAL FEEL"status indicator (C9) becomes white for approx-
imately 1 minute to indicate that the appliance is checking the room
conditions.
Afterwards the"ECO REAL FEEL"status indicator (C9) changes color
as it approaches comfort conditions (see following diagram).
For this type of use, the appliance must be set up in the air con-
ditioning mode.
HIGH
MEDIUM
LOW
TEMPERATURE
button (D9) on remote
Operating curve
Perfect!
Publicité
