Environmental Concerns - Fust NOVAMATIC KS-TF 315.2-IB Notice D'utilisation

To change the
opening direction of
the door, do these
steps:
• Remove the plug
from the power
socket.
• Tilt back the appli-
ance carefully so
that the compres-
sor cannot touch
the floor.
• Remove the
plinth.
• Unscrew and re-
move the lower
hinges.
• Remove the door.
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to the
side edge of the appliance.
• The magnetic seal adheres to the cabi-
net.
• The door opens and closes correctly.
Do a final check to make sure that:
• All screws are tightened.
• The edges of the doors run parallel to the
side edge of the appliance.
• The magnetic seal adheres to the cabi-
net.

ENVIRONMENTAL CONCERNS

The symbol on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will
help prevent potential negative
2
1
• Unscrew the up-
per pin and screw
it on the opposite
side.
• Refit the door.
• Make sure the
edge of the door
is parallel with the
edge of the top.
B1
B2
B3
• Unscrew the pin
(B1) and screw it
on the opposite
side.
• Remove the cap
(B2) and position
it on the opposite
side.
• Screw the lower
hinges.
• Refit the plinth.
• Stand the appli-
ance upright.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The After
Sales Service specialist will carry out the re-
versibility of the doors at your cost.
consequences for the environment and
human health, which could otherwise be
caused by inappropriate waste handling of
this product. For more detailed information
about recycling of this product, please
contact your local council, your household
waste disposal service or the shop where
you purchased the product.
h2
h1
h3
• Fit the handle on
the opposite side
and put the plastic
caps (contained in
the instructions
bag) in the free
holes.
13