Bresser TOPAS 7x50 Mode D'emploi page 6

never look directly at the sun with the
binoculars. this may cause burn injuries to
the retina.ᇌ
b
Individual eyepiece adjustment
c
Rubber eyecup
d
Compass
e
Battery compartment
f
Compass lighting ON/OFF button
g
Rotating distance calculation scale
h
Threaded tripod connection
i
Reticle
scharfeinstellung
The distance between the eyes differs between individuals.
To achieve optimal centring of the eye and eyepiece axis look
through the binoculars and change the angle of the centre axis by
folding or expanding until you have a clear field of view.
adjusting the focus
Your binoculars have single eyepiece adjustment (1) means. To
focus look at an object approximately 100 meters away. Close only
your left eye and keep turning the right eyepiece setting ring 1 until
the object looked at is in sharp focus. Then close only your right eye
and turn the left eyepiece setting 1 until the object you are looking at
is again in sharp focus. The binoculars are now precisely adjusted to
your eyesight.
The single eyepiece setting (1) is designed to give you
better perspective. When switching between objects of
varying distance the focus need only be readjusted if the change in
distance is really major.
reversing the eye-piece cup (3)
Note for spectacles wearers. The rubber eyepiece cups (2) are rever-
sed when using spectacles to look through the binoculars. The maxi-
mum field of view of the binoculars can thus be exploited to the full.
compass (3)
Your binoculars are equipped with a compass. If you look through
them you will see a scale in degrees (0 - 360) at the lower edge of
your field of view. If 360 is exactly at the centre of the scale you are
looking directly to the north (if 180, to the south).
compass lighting
In darkness you can turn on the compass lighting by lightly de-
pressing the On/Off button (5). The lighting stays on as long as the
button is depressed.
changing the batteries (Fig. 2)
Remove the plastic battery compartment cover (4) by raising it
- 6 - - 6 -