Maintenance And Repair - ALFRA ROTABEST 100 RL – E Mode D'emploi

Cleaning
Danger of injuries by unintentional switching on. Pull plug prior to cleaning.
Clean motor by means of dry compressed air ( from the outside).
Check connecting lines on damages.
Clean and grease sliding surfaces regularly. Should, nevertheless, lateral play arise by
wear of the dovetail guide, this could be adjusted by adjusting the laterally positioned
set screws (K).
Carbon brushes should be replaced after appr. 250 hours running time.
After the work is finished, we recommend to store the Metal Core Drilling Machine in
the transport case in a lying position.

Maintenance and repair

Maintenance, check and repairs are only to be made by electronics specialists
according to the valid regulations of the respective country.
The Metal Core Drilling Machine ALFRA ROTABEST should be serviced after
appr. 250 hours running time by our ALFRA workshop or appointed dealers. The
Gear oil (Lubcon, Turmogearoil PE 150 300ml) should be exchanged as well as
the brushes.
Only use genuine ALFRA spare parts.
Spare part list at the end of this operation manual.
22