Service Menu For Rls 45 O - Maico PP 45 O Notice De Montage

UK | 10 Start-up

10.2 Service menu for RLS 45 O

LEDs
LED flashing modes:
44
Parameter Set value /
ventilation level
Device type 1
on RLS 2
(Fan1/Fan2)
1
Number of device
pairs/ 2
devices on RLS 3
(Fan1/Fan2) 4
5
Ventilation levels 1
2
0
Power units
(LT) or 1
room air 2
controls 3
(RLS) 4
5
6
LED flashing rapidly
bold = factory setting
Setting /
description
PP 45
PPB 30 O
The type family, which is connected
to the Fan1/Fan2 fan interface, is
selected here.
Notice: Only single-type PP 45 or
PPB 30 unit combinations are per-
mitted at the fan interface!
1 device pair PP 45 or 1 PPB 30
2 device pairs PP 45 or 2 PPB 30
3 device pairs PP 45 or 3 PPB 30
Odd number, 3 devices PP 45
Odd number, 5 devices PP 45
The number of units connected to the
fan interface (Fan1/Fan2) is selected
here.
Ventilation level "0" possible
Ventilation level "0" blocked
With the ventilation level "0" blocked
setting, the ventilation units cannot
be switched off on this control. The
units then run with at least ventilation
level 1.
Operation without further LT/RLS
Operation with 1 LT or RLS
Operation with 2 LT or RLS
Operation with 3 LT or RLS
Slave no. 1
Slave no. 2
Slave no. 3
Adjuster for adding further room air
controls (RLS) or power units (LTs) to
this room air control. Example: Two
further RLS (RLS #2 and #3)
are connected to RLS #1. Set
value = 2. Set set value 4 on RLS #2
and set value 5 on RLS #3.
Notice: Only single-type RLS com-
binations are permitted!
LED flashing slowly