Weller WE 1 Traduction De La Notice Originale page 16

EN
ENGLISH
User groups
Due to differing degrees of risk and potential hazards, sever-
al work steps may only be performed by trained experts.
Work step
Default soldering para-
meters
Replacing electrical repla-
cement parts
Default maintenance
intervals
Operation
Filter change
Operation
Filter change
Replacing electrical
replacement parts
Care and maintenance
WARNING
Before doing any work on the machine, pull
the plug out of the socket. Leave the unit to
cool down.
Check all connected cables and hoses on a regular basis. If
power tools are damaged, they must be immediately
removed from use.
Only replace the soldering tips when they are cold.
The soldering tool must be left switched off in the safety rest
for at least 3 minutes until the soldering tip has cooled down.
The LED status indicator must be at „OFF".
Keep the heat transfer surfaces of the soldering tip and
heating element clean. The heating element must not come
into contact with soldering tin.
Repairs must always be referred to a Weller-trained
specialist.
Use original replacement parts only.
Warranty
Claims by the buyer for physical defects are time-barred
after a period of one year from delivery to the buyer. This
does not apply to claims by the buyer for indemnification in
accordance with §§ 478, 479 BGB (German Federal Law
Gazette).
We shall only be liable for claims arising from a warranty
furnished by us if the quality or durability warranty has been
furnished by use in writing and using the term „Warranty".
The warranty shall be void if damage is due to improper use
and if the device has been tampered with by unauthorised
persons.
16
User groups
Specialist personnel with
technical training
Electricians
Safety expert
Non-specialists
Technical trainees under
the guidance and supervi-
sion of a trained expert
For more information please visit
www.weller-tools.com.
Technical Data
soldering station
Dimensions L x W x H
Weight
Mains supply voltage
Power consumption
Safety class
Temperature range
Tool dependent
Temperature accuracy
Temperature stability
Soldering iron
Temperature range
Power consumption
Mains supply voltage
Heat-up time
(50°C to 350°C) (120°F to
660°F)
Tip top condition
Supply unit
Subject to technical alterations and amendments.
Temperature performance
The soldering tool has an internal usage sensor which can
be used to set an automatic switch-off function (Stand-by).
The settings can be found in the station's operating instruc-
tions.
WE 1
(mm) 150 x 125 x 100
(Inch) 5,91 x 4,92 x 3,94
(kg) 1,9
( V / Hz) 230 / 50/60
120 / 60
100 / 50/60
(W) 85
I, antistatic housing
III, Soldering tool
(°C) 100 - 450
200 - 850
(°F)
(°C/°F) Average tip tem-
perature can be
„offset" to +/- 5°C
(+/-°9F) at idle with
no load
(°C/°F) ± 6 / ± 10
WEP 70
(°C / °F) 50-450
70
(W)
23
(V AC)
28
(s)
ET
WE 1