EUROM Safe-t-Convect 2200 Manuel D'utilisation page 32

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Note: Attach the feet first before using the heater:
Turn the heater upside down. Place a blanket (or something similar) under the

heater to prevent damage!
Slide the feet from the side so that the grooves go as far as they can over the

protruding brackets; this will ensure that the threaded holes will align correctly.
Securely attach the feet to the heater using the short self-tapping screws.

Return the heater to the upright position.

Select a suitable

aforementioned wanings in this manual.
Check if the ON/OFF switch (D) is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V

connect the heater to an earthed socket! To prevent the circuit overloading,
check that no other appliances are connected to the same group.
Set-up and operation
1. Output button
2. Celsius↔Fahrenheit button
3. Receiving point – remote control
4. Stand-by button
Set the ON/OFF switch (D) to 'ON' (I). The display shows the current temperature
(left) and the set temperature (right) which is 25°C as standard. The device is now
in stand-by.
location for the device taking
5. Ventilator button
6. Higher button
7. Lower button
8. Timer
32
into account all
socket. Only
the