EUROM B-4 PTC Heater Manuel D'utilisation page 26

5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences
Description
1. control dial
2. Pilot light
3. thermostat dial
4. air outlet grill
5. air intake grill (backside)
6. feet
Location and connection
 Remove all packaging material and keep out of reach of children. After
removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
 The device must not hang, but must stand upright.
 Check if the control dial is set to 'OFF' (O).
 Fully extend the power cord and plug into a suitable 220/240V socket. To
prevent the circuit overloading, check that no other appliances are connected to
the same group.
Set-up and operation
 Turn the thermostat dial to maximum (clockwise as far as possible).
 Switch the heater on by turning the control dial to one of the following three
positions:
Fan only (thermostat always to maximum)
Heating at half power (750 W)
Heating at full power (1500 W)
The light at the front will turn on.
It is most economical to heat the space at full power, then to switch to half
power to maintain the temperature.
26