Alesis Turbo Drum Module Guide D'utilisation page 4

Setup
Items not listed in Introduction > Box Contents
Connecting the Drum Module
Selecting a Kit
To select one of the module's 10 preset kits, do one of the following:
• Press the Variation button so it is lit red,
and then press the 1, 2, 3, 4, or 5 button to
select Kit 1, 2, 3, 4, or 5 respectively.
• Press the Variation button so it is lit green, and then press the 1, 2, 3, 4, or 5
button to select Kit 6, 7, 8, 9, or 10 respectively.
The Kit Number will appear in the Display. Once you have selected a kit, you can select others
by repeating one of the steps above or by using the – / + buttons.
Playing the Pads
If your electronic drum kit has velocity-sensitive pads, Turbo Drum Module will play sounds of
varying timbres depending on how hard you hit the pads. Try hitting the pads with different
amounts of force to experiment with the different sounds produced by the module!
The hi-hat sound will vary based on the position of the hi-hat controller pedal:
•
Open hi-hat: With your foot off the pedal, hit the hi-hat pad.
•
Closed hi-hat: With your foot pressing the pedal all the way down, hit the hi-hat
pad.
•
Pedal close: Press the hi-hat pedal all the way down without hitting the hi-hat pad.
•
Splash: Quickly press the hi-hat pedal all the way down, and then release it
immediately.
Learn more about using the drum module in the
4
Drum Module Rear Panel
Connect the head of the included cable snake here
(multipin with two screws). Then connect the 1/4"
cables at the tail end of the cable snake to each pad
in your drum kit.
are sold separately.
1 2
Operation section of this manual.
3 4 5
VARIATION