SIKA P 700 T Notice D'utilisation page 37

P 700 T
Replace oil:
The SIKA hydraulic oil 10 cSt needs to be completely replaced after 12 months at the latest. In
case of use conditions with heavy soiling, the hydraulic oil needs to be replaced more often.
 Turn the seal to the "O P E N" position and remove it from the reservoir.
 Tilt the P 700 T over a suitable collecting container.
 Drain the old oil completely from the reservoir.
 Place the P 700 T on a level surface and fill in new oil:
Only use original SIKA hydraulic oil10 cSt.
Filling capacity ~325 ml.
 Insert the seal in the "O P E N" position on the reservoir and turn it to the required posi-
tion.
 Dispose of the old hydraulic oil according to the instructions in the safety data sheet.
Cleaning:
Clean the P 700 T with a dry or slightly damp lint-free cloth.
Do not use sharp objects or aggressive cleaning agents to clean the P 700 T. Avoid contact
with aggressive media.
Storage and transport:
For storage and transportation we recommend our transportation case, which is available as
an accessory.
Only carry the P 700 T on the hand lever, the reservoir or the base plate. Hoses or other com-
ponents are not suitable for this purpose.
The tight-fitting rigid foam inlay offers optimum protection for the P 700 T with pressure hose
and accessories.
REFERENCE / REFERENCE GAUGE
The common reference models fit into the gaps in the transportation case and do not
need to be removed.
Before storage, we recommend that you consider the following points:
 Clean the P 700 T and the accessories.
 Turn the fine adjustment valve clockwise until the thread is
no longer visible ( illustration).
 Open the pressure relief valve.
Verify that the seal of the reservoir is in the "C L O S E" po-

sition!
IMPORTANT! Do not store under pressure!
Only store the hand pump with the pressure relief valve open.
This ensures that no pressure can be built up by unintentional pumping movements.
Technical changes reserved
Maintenance / cleaning, storage and transport
- 37 -