Product Description - DENTAURUM ConTec Go Mode D'emploi

Dear Customer
Thank you for having chosen a quality product from Dentaurum.
In order to use this product at its best for you and your patients, it is important to study and follow
these instructions for use carefully.
The written instructions cannot cover all eventualities during operation. For this reason, our Hotline is
available to answer any other questions and ideas that may arise.
Due to constant developments we recommend, even when you use our products regularly, to study the
enclosed current instructions for use or to refer to our website at www.dentaurum.com
1. Manufacturer
Dentaurum GmbH & Co. KG I Turnstr. 31 I 75228 Ispringen I Germany
2.

Product description

ConTec Go! is a ready-to-use bracket adhesive consisting of an adhesive paste and an activator.
The curing process starts by means of pressure. Mixing is not necessary.
3. Indication
Bracket adhesive for bonding metal, plastic and ceramic brackets.
4. Hints for use
Avoid early contamination of adhesive paste and activator.
5. Recommended use
5.1. Clean the tooth surfaces thoroughly. For cleaning, use for instance small brushes and rubber
cups with cleaning pastes. Please make sure that the cleaning pastes contain no fluoride, oil and
grease. Clean at low speed.
5.2. Dry the tooth surfaces with cotton rolls or rubber dam.
Caution: the etching gel may cause chemical burns. Avoid etching gel contact
5.3. Apply the etching gel on the enamel surface. Leave out the crowns and fillings.
5.4. The etching gel should operate for 20 – 60 s.
5.5. Rinse off the etching gel with a strong jet of water. Rinse each tooth at least 5 s.
with the gingiva, dentin, soft tissue, eyes and skin. If contact occurs,
immediately flush with water or get medical attention.
EN
7