Advice For Operation; Stop; After Operation; Routine Maintenance - Stiga SP 316 Manuel D'utilisation

During the operation, to maintain control when
the cut is almost complete, reduce the bucking
pressure without removing removing your
hands from the machine hand grips. Take all
necessary precautions to prevent the machine
from coming into contact with the ground.

6.6 ADVICE FOR OPERATION

NOTE Avoid using the machine at full
power for the first 6- 8 working hours.
IMPORTANT Stop the machine (par.
6.6) when moving between work areas.
Stop the machine immediately
if the chain stops during sawing.

6.7 STOP

To stop the machine:
1. Release the throttle trigger lever (Fig.
12.B) and allow the engine to run at
minimum speed for a few seconds.
2. Turn the switch (Fig. 13.D)
to the «O» position.
3. Wait until the chain is stationary.
When you have reduced speed
to a minimum, it will take a few
seconds for the chain to stop.
The engine may be very warm
immediately after it is shut off. Do not
touch. The engine can cause burn injuries.

6.8 AFTER OPERATION

– Remove the spark plug cap (Fig. 25.A).
– Mount the bar cover.
– Allow the machine to cool down.
– Loosen the guide bar fastening
nut to reduce chain tension.
– Carefully remove any dust and debris
and remove all traces of sawdust or oil
deposits from the chain. (par. 7.5, par. 7.6).
– Check there are no loose or damaged
components. If necessary, replace the
damaged components and tighten
any screws and loose bolts.
IMPORTANT Stop the machine (par.
6.9) remove the spark plug cap (Fig. 25.A)
and mount the bar cover whenever the
machine is unused or left unattended.

7. ROUTINE MAINTENANCE

7.1 GENERAL INFORMATION

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or dangers.
Before conducting any inspections,
cleaning or maintenance/adjustment
interventions on the machine:
• Stop the machine;
• Wait until the chain is stationary;
• Apply the bar cover, except when working
directly on the chain or bar itself.
• Remove the spark plug cap (Fig. 25.A);
• Wait until the engine is sufficiently cold;
• Read the relevant instructions;
• Use suitable clothing, protective
gloves and goggles;
• The frequency and types of maintenance are
summarised in the "Maintenance Table" (see
chapter 13). The table will help you maintain
your machine's safety and performance.
It summarises the main interventions to
be made and the frequency applicable to
each of them. Carry out the relevant task as
soon as it is scheduled to be performed.
• The use of non-genuine spare parts and
attachments could adversely affect machine
operation and safety. The manufacturer
declines all liability for any damage or
injuries caused by these products.
• Genuine spare parts are supplied by
Authorised Service Centres and dealers.
• Never use the machine with worn or
damaged parts. Damaged parts are to
be replaced and never repaired.
IMPORTANT Any maintenance and
adjustment operations not described in
this manual must be carried out by your
dealer or Authorised Service Centre.

7.2 PREPARING THE FUEL MIXTURE

This machine has a two-stroke engine which
requires a mixture of petrol and lubricating oil.
IMPORTANT Using petrol alone will damage
the engine and will void the warranty.
EN - 12