Explanations - Becker Centronic SunWindControl SWC545-II Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Manual/Automatic sliding switch
In the "" mode, only manual control commands and alarm signals are executed
(e.g.: by pressing RETRACTION, STOP, EXTENSION buttons and wind alarm).
When the sliding switch is set to "" mode, automatic control commands are
carried out (e.g. Automatic sun protection function, ...).
The automatic sun protection functions are interrupted if a manual operation is
executed during automatic mode. These functions are re-activated automati-
cally when the programmed threshold values are exceeded or undercut after
retraction or via switching the slide switch from "" to "" and back to "".
Channel
The channel of a handheld transmitter can be programmed into one or several
receivers. One or several receivers are controlled via an individual or group com-
mand respectively.
Central command
If all the transmitter channels are selected, all the assigned receivers/receiver
groups can be controlled simultaneously.
Channel selector button
The channel selector button can be used to select up to 5 channels. The indi-
vidual channels are indicated by the respective channel control light being il-
luminated.
If all the channel control lights illuminate simultaneously, the central command
can be programmed or executed.
Note
The programmed channel can be written down in the labelling space
underneath the transparent cover.
32

Explanations