Installation - Progress PES6061E Notice D'utilisation

16 Progress
What to do if...
Problem
You cannot activate or oper-
ate the hob.
Residual heat indicator does
not come on.
There is a dark area on
the multiple zone.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Make sure, you
operated the hob correctly. If not the

INSTALLATION

WARNING! Refer to Safety
chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Possible cause
The fuse is released.
The zone is not hot because
it operated only for a short
time.
It is normal that there is a
dark area on the multiple
zone.
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.
Remedy
Make sure that the fuse is the
cause of the malfunction. If
the fuse releases again and
again, contact a qualified
electrician.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.