WANDERS Larix Mode D'emploi Et Instructions D'installation page 29

• remove the upper and lower covers (A
and B) by carefully pulling them towards
you,
• remove the 6 bolts (M5), after which the
top and bottom clamp strips (C) can be
removed,
• grab the glass (D) on both sides and
carefully pull it towards you,
• put the glass in a safe place, preferably
on a blanket, to prevent damage.
• Carefully return (D) the glass. After
replacing the glass, make sure to clean
it thoroughly before lighting the heater.
Fingerprints will burn into the glass.
• return the top and bottom clamp strips
(C). Be careful not to over-tighten the bolts, as this can
cause the window to break.
• Slide the top and bottom front covers (A and B) back
into place.
Watch out for fi nger marks!
Make sure to leave no fi nger marks on the
cleaned glass pane when you close the hearth
door. Finger marks leave stains which will burn
in the glass.
Placing the fi replace (hanging)
• The device must be mounted to a suffi ciently sturdy wall.
• Mount the bracket on the wall, using the correct bolts.
• Remove the top and bottom front covers and the glass, as described on page 29.
• Hook the heater into the appropriate slots in the mounting bracket. Make sure not to overstress your back.
• Make sure to keep fl ammable materials, such as curtains, well clear of the system at a minimum distance of 1.5m.
350,00
C C
D D
GB
A A
B B
29