SOLIS PERSONAL BARISTA Mode D'emploi page 57

Make sure that the steam / hot water wand is in its original position, meaning
●
swivelled all the way in.
Place a cup under the brewing head and onto the drip tray.
●
Press the ON/OFF button (1). Once you have switched the machine on with this
●
button, the button surrounds of the ON/OFF button and the grinding button (6)
light up in white and the yellow temperature lamp (2) indicates that the appliance
is in heating up mode. Once the machine has reached the temperature necessary
for coffee extraction, the yellow temperature lamp goes out and the appliance
is ready for use.
GB
Press the coffee extraction button (4) and let water run through the brewing head
●
for approx. 1 minute, then press the coffee extraction button (4) again.
Swivel out the steam / hot water wand. Only touch the wand by the rubber part
●
to prevent scalding yourself.
Place a container under the steam / hot water wand.
●
Press the coffee extraction button (4) again, hot water runs out of the wand.
●
Let hot water run through the wand for approx. 1 minute, then press the coffee
extraction button (4) again to stop the hot water function.
Swivel the steam / hot water wand back into its original position so that it is folded
●
all the way in.
Turn the portafilter handle to the left.
●
Pull the portafilter with the filter insert down and out. CAUTION: Both parts are
●
hot, be careful not to scald yourself.
112
E SP R E SSO MA K I N G W IT H Y O U R
s
S O L I S P E R SO N A L B A R I STA
NOTE: Check the water level in the water tank before every use. Change out
the water daily. Empty and fill the water tank before every use with fresh,
cold tap water up to 1 cm under the edge of the water tank. Do not use any
distilled or carbonated water, mineral water or other liquids.
GRIN DIN G CO FFEE I NTO THE FILTER I NSER T
■
AN D T A MPIN G I T
Fill the bean container (20) with whole, fresh coffee beans. Close the bean con-
●
tainer with the lid (21). The "0" on the bean container should line up with the
arrow on the cup shelf.
Press the ON/OFF button (1) to switch the appliance on. The white button sur-
●
rounds of the ON/OFF button and the grinding button (6) light up.
CAUTION: Make sure that the buttons for the steam function (3) and coffee extrac-
tion (4) have not yet been pushed in, meaning they are not lit up. Otherwise, the
grinding function does not work!
Set the control knob for the quantity of ground coffee (7) to the desired position.
●
The further you turn the knob in a clockwise direction towards "Max", the larger
the amount of ground coffee will be.
Turn the bean container (20) so that the arrow on the cup shelf points to the
●
desired grind size setting. You can turn the bean container both in a clockwise
and a counter clockwise direction. The higher the set number is, the more coarse
the grind will be. 1 is the finest grind size, 25 is the coarsest grind size.
The grind size should only be adjusted while the grinder is running.
Place the filter insert for one cup (25) or for two cups (24) in the portafilter (23),
●
so that it locks into place. If you want to make a big cup of coffee, use the filter
insert for two cups and let more water run through – depending on the desired
intensity of the coffee.
GB
113