Sprue Safety Products WTSL-F-1EU Mode D'emploi Et Guide D'installation page 8

How to 'learn in' the Alarm Control Unit
to a wireless network:
1. Using a ballpoint pen, briefly push and release
the 'learn button'
unit. The red LED next to the learn button will
flash briefly then light up for approximately
5 seconds.
Learn button
8
on the back of the control
2. During these 5 seconds you need to briefly
press the test button on an alarm already in
the network, to wirelessly interlink the two.
The alarm will sound its audible test pattern
3. The red LED on the back of the control
unit will flash to indicate that it has been
'learned-in' successfully. If the test button
is not pressed quickly enough, the 'learn-
in' process will fail. If this happens, repeat
the process. Your Alarm Control Unit counts
as one unit within the network. If it is installed
retrospectively, then the existing network
cannot exceed 49 units in
4. To complete the installation simply slide the
control unit onto the bracket. The control unit
is now part of the whole network.
size.