Alarm Memory - Sprue Safety Products WTSL-F-1EU Mode D'emploi Et Guide D'installation

LOCATE BUTTON
If the alarms are sounding and an alarm
indicator is flashing, but there's no obvious
hazard, pressing the 'Locate' button (
silence all wirelessly interlinked alarms except
for the initiating alarm which has sensed smoke
/ heat or carbon monoxide. Within two minutes
the system will return to normal operation and
the alarms will continue to sound if smoke / heat
or carbon monoxide is still present. To make
locating the alarm easier, the control unit can be
removed from its bracket and carried around the
property (providing the tamper proof function
has not been engaged), allowing you to press
the 'Locate' or 'Test' button whilst moving from
room to room.
SILENCE BUTTON
If the alarms are sounding and the smoke / heat
alarm indicator is flashing, but there's no obvious
hazard, pressing the 'Silence' button
silence all wirelessly interlinked alarms and
reduce the system sensitivity for up to 10
minutes. However if excessive smoke is sensed
the silence function will be overridden. The
) will
indicator will continue to flash unless the smoke
disappears. Please Note: An alarm cannot be
silenced using the Alarm Control Unit if carbon
monoxide has been detected, however the
'Locate' function will allow you to find out which
of the CO alarms is the initiating alarm.

ALARM MEMORY

If one of the alarm indicators is flashing every
10 seconds this indicates that a smoke alarm,
heat alarm or carbon monoxide alarm has
previously been activated. Pressing the 'Locate'
button (
the source alarm so you can investigate this
further. You can press the 'Locate' button
repeatedly until the source alarm is identified
(fully compatible with
( ) will
smoke*, heat and CO alarms).
) will clear the LEDs and sound
FireAngel 230V
( )
Wi-Safe 2
13