Reorganisinga Network - Sprue Safety Products WTSL-F-1EU Mode D'emploi Et Guide D'installation

REORGANISING
A NETWORK
If you have un-learnt and replaced or removed
any alarms, you can 'reorganise' in order to
optimise the network performance. To do this
you will need to press and hold the 'Locate'
button for 5 seconds. The Alarm Control Unit
will then enter 'Reorganisation Mode', during
which time you will see a series of flashes from
the LEDs. The time taken for this process to
complete will depend on the number of units in
the network.
If successful, once
complete, the Control Unit should return to
standby mode, with no LEDs flashing.
If the reorganisation is not successful, and
LEDs are still flashing (all 3 LED's flash together
- + + - 3 times , then a fourth flash
the reorganisation
( + only) occurs repeatedly, you will need
to exit 'Reorganisation Mode'. To do this hold the
'Locate' button for 5
and then repeat the process
Prior to performing network reorganisation,
test the network by pressing the test button
on one of the randomly selected units and
ensure that all units chirp / flash in response.
This is essential to make sure that all the
units are communicating with each other and
ensures network reorganisation does not delete
wanted units. In case one of the working units
is out of range for networking, please check the
installation position of the units and adjust /
is
install an additional unit to help with the routing
of messages.
seconds, wait for 5 minutes
above.
15