Testing The Alarm System - Sprue Safety Products WTSL-F-1EU Mode D'emploi Et Guide D'installation

USER GUIDE
TESTING THE ALARM
SYSTEM
Press the Test / Silence button to confirm that
the control unit is operating properly. This will
instigate a three minute test. All networked
alarms should sound. To stop the test (earlier
than 3 minutes), simply press the Test / Silence
button again. This test should be performed on a
weekly basis.
Pressing the Test button on the Alarm Control
Unit creates a lot of RF traffic. If you need to use
the feature more than once, please wait for 5
minutes to let the network settle down.
11