Arktic 233788 Mode D'emploi page 7

Indicator light status description
Symbol indicator
C
def
Set the temperature
• Plug into a suitable electrical outlet.
• When set indicator light is OFF, press and hold
1a. button for 3 to 4 seconds until
the display. Then, release the 1a. button & press
1a. button again.
• Next, press 1b. button to increase the setting
temperature by 1°C or press 1c. button to de-
crease by 1°C.
Defrost
• The appliance will start defrost process automat-
ically for every 6 hours.
Shelf height adjustment
• The height of each shelf can be adjusted.
Installation instructions
• Remove the appliance from the carton box, then
remove the external and internal packaging and
wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages, DO
NOT use the appliance. Please contact supplier
(See ==> Warranty).
• Let the appliance stand upright for about 2 hours.
This is to reduce the malfunction of the cooling
system from improper handling during transpor-
tation.
• Clean interior surface with warm water and soft
cloth. (See ==> Cleaning and Maintenance).
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
• Place all the shelves inside the appliance securely.
Status
ON
OFF
ON
OFF
FLASH
ON
ON
• After that, press 1d. button to confirm the setting
and exit.
is shown on Note:
• If no button is pressed within 30 seconds, the
newly set temperature will be stored automati-
cally.
• The temperature setting ranges from 2°C to
10°C.
• When def indicator is ON, the appliance is under
defrost process.
• Adjust the height of each shelf according to the
height of the items.
• Optimum working ambient temperature is be-
tween 16°C and 30°C. Otherwise, the functional-
ity will be limited.
• Ensure that there is sufficient ventilation. Keep
a minimum distance of 10 cm around the appli-
ance. Do not block the ventilation holes.
• For energy savings, always make sure the door
is closed.
• Ensure that you have all the accessories and
tools needed for assembly and operation. This
also includes suitable personal protective equip-
ment (e. g. gloves, not included).
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
Description
Under setting mode
Operating under the setting condition
Compressor works and cooling active
Compressor not works and cooling inactive
Preparing cooling process
Under refrigeration process
Under defrost process
EN
7