Viscount UNICO CL 7 Guide De L'utilisateur page 42

Viscount
UNICO
[HR] restores the voice setup prepared in manual mode before a memory was recalled.
General combination sequencer controls are also provided, [PREV] in descending order, [NEXT.] in
ascending order.
14. [S] piston.
Fixing piston for saving the general and dedicated combinations, the Tutti and the Crescendo steps.
To set a combination or the Tutti, after setting the voices as required, press [S], hold it down and then
press the piston of the combinations you wish to save.
To save a Crescendo step, select it using the pedal of the same name, press [S], hold it down and press the
[HR] of the general memories. To copy the contents of one step into another, select the step you wish to
copy, hold down the [S] piston, select the step into which you wish to copy the contents, then press the
[HR] of the general memories.
NOTE
If the LED of the [S] piston is off, programming of the organ is locked out by the Lock Organ function
(chapt. 10), so it will not be possible to save combinations and/or view internal programming functions.
15. Organ general controls.
These controls do not refer to individual sections but to the entire instrument.
- [MEM. BANK +] and [MEM BANK -]: they select the memory bank displayed by the additional
[MEM. BANK] display (point 12).
- [ENC]: enables the Enclosed function, which allows the organ's general volume to be controlled
using the swell pedal [MAN. III] in the CL / CLV 8 or [MAN. II] in the CL / CLV 7.
- [A.P.]: enables the Automatic Pedal which allows the pedal voices to be played on Man.II in the CL /
CLV 8 or Man.I in the CL / CLV 7.In this case, the organ's pedal board is deactivated and the voices
become monophonic, with priority to the lowest note.
- [T]: piston and foot piston for recalling the Tutti. The Tutti can be modified; the procedure for saving
it is described in point 8.
- [C]: Cancel piston
NOTE
Memory bank n. 1 is always selected when the instrument is switched on.
16. Reversible toe-studs.
When activated, these pistons can be used to turn off the controls associated to them. Deactivating the
pistons turns the control functions back on.
- [MIDI REVERS.]: switches off the MIDI controls. The MIDI control setup required can still be set
even with MIDI Reversible activated.
- [32' FLUTE REVERS.]: switches off the 32' flutes.
- [32' REED REVERS.]: switches off the 32' reeds.
17. Front connections panel.
This panel, on the left underneath the manuals, contains the connectors and settings most often used, for
convenient access.
- [MASTER VOLUME]: regulates the organ's general volume.
- [REVERB VOLUME]: regulates the level of the reverb effect.
- MIDI [IN]: the MIDI input connector for allowing the organ to receive the data transmitted by a
remote MIDI unit.
7
/ 8 /
-
40
User Guide