HSM Primo 4001 Notice D'utilisation page 16

Bag for shredded material full
Red LED on membrane key-
board lights.
Paper shredder stops automati-
cally.
Notice Empty the cut material container,
immediately because if it is too full, malfunc-
tions can occur in the cutting system.
Note Reversing the cutting device
("Reverse" button) is also possible even
when the shredded material container is full.
• Insert new bag.
For all other malfunctions, before calling
customer service please check
– if the motor was overloaded
Let the shredder cool down for approx.
15 – 20 mins. before using it again.
– if the light barrier is soiled with paper
dust.
Clean the light barrier in the paper feed
using a dry brush or cloth.
16
8 Cleaning and maintenance
Switch off the shredder and pull out the
mains plug. When cleaning only use a soft
cloth and a mild soap-water solution. How-
ever, no water must enter the equipment.
Check that the door switch is working
properly:
WARNING
If the following procedure cannot
be performed, switch off the
document shredder, disconnect
the mains plug and contact
customer service.
• Insert the mains plug and switch on the
shredder.
• Feed in a sheet of paper and open the
front door while the paper is being drawn
in.
The cutting unit must turn off immediately
and the "door open" indicator must light
up.
• Close the door.
The cutting unit must not yet restart.
• Pull the paper out of the feed opening.
The light barrier must be clear.
• Switch off the machine and then switch
back on.
The cutting unit starts when paper is fed
in.
• Spray special cutting block oil
through paper feed opening
across the whole width of the cut-
ting system blades.
• Run cutting system forwards and
backwards several times without
feeding paper.
Paper dust and particles are
shaken off.
Primo 4001
english english
Oil the cutting unit when
cutting performance de-
creases or the device
becomes noisy, or every
time you empty the waste
container:
09/2011