HSM Primo 4001 Notice D'utilisation page 15

Swit ching paper shredder off
• Set mains switch at rear of paper
shredder to „0".
Destroying credit cards, CDs, discs or
DAT cassettes:
Cross cut machines:
Fold the safety element down (only for cut-
ting types 3.9 x 50 mm and 1.9 x 15 mm),
switch the machine on to continuous opera-
tion and feed the material into the insertion
slot.
only for cutting type
3.9x50 mm 3.9x50 mm • 1.9x15 mm
Floppy disks Credit cards + CDs
For strip cut machines, feed the CDs, credit
cards or discs directly into the paper feed
slot.
Destroying USB sticks
with cut size 5.8, 3.9, 3.9 x 50, 1.9 x 15 mm)
Insert USB sticks in the centre of the paper
feed.
09/2011
only for cutting type
3.9x50 mm
DAT cassettes
(only machines
7 Troubleshooting
Pa per jam
You have fed in too much paper.
Paper shredder jammed.
Red LED in the key pad fl ashes.
Paper shredder reverses auto-
matically.
Notice!
Do not press dashed arrow button and
green arrow button alternately forwards and
backwards. Cutting unit can be damaged.
• Pull paper out of the paper feed-
ing opening.
If material is not completely pushed
out, then
• Press dashed arrow button.
Paper is pushed out.
• Pull paper out.
• Separate paper stack
• Feed in pa per successively.
Electric motor overheated
Red LED on membrane key-
board lights.
Paper shredder switches off au-
tomatically.
• Allow paper shredder to cool
down for approx. 15 to 20 min.
Front door is open
Red LED on membrane key-
board lights.
Paper shredder stops automati-
cally.
• Close front door.
Note If the door is opened when the
cutting device is running, the document
shredder must be started again using the
green button after the door of the document
shredder has been closed.
Primo 4001
english english
15