Raising The Ponybench Bpplus; Lowering The Ponybench Bpplus Lift - spanesi PONYBENCH BPPLUS Manuel D'utilisation Et De Maintenance

4.2.3 RAISING THE PONYBENCH BPPLUS

WARNING! The PONYBENCH BPPLUS can be
used only by duly instructed and authorised
personnel. Make sure that there are no persons
and/or foreign objects in the work area before
performing manoeuvres with the lift. Make sure
that the vehicle is correctly positioned on the
lift before proceeding to further operations.
After checking the correct operation of the safety devices,
the PONYBENCH BPPLUS lift can be used for work.
Check that the mobile platform is fully lowered and
that the lifting arms are consequently closed.
Proceed as follows (fi g. 7):
• Make sure that the control console is connected to
the compressed air system set to the right pressure
(see Par. 3.2.3 CONTROL OPERATIONS TO BE
PERFORMED BEFORE INSTALLATION).
• Position the vehicle above the lift's movable platform.
• Position the vehicle on the lift in such way that its
weight is distributed as evenly as possible.
• Any doors present must be closed.
• There must be no objects protruding from the vehicle.
WARNING! Remember that when parts of the
vehicle are dismantled, the centre of gravity is
altered. This must be taken into account when
positioning the vehicle on the lift.
• Before raising the lift, check that there are no persons
and/or animals less than one metre from the perimeter
of the lift or vehicle.
• Rotate the <ascent> selector (2) while simultaneously
rotating selector (3)clockwise until the lifting arms
emerge from the pit. Position the 4 rubber vehicle
support buffers provided onto the lifting arms: adjust
the lifting arms and buffers until the rubber disks are
positioned on the respective lifting points beneath the
underside of the vehicle's body.
• Raise the vehicle approx. 30 cm above the ground,
and then stop movement. Check the stability of the
vehicle, and then continue raising the lift by rotating
the <ascent> (2) selector again until the required
height is reached. Release the button: the lift will stop
in the required position.
• If the height of the premises where the lift is installed is
insuffi cient, be careful not to crush the vehicle against
the ceiling when raising the lift.
• Make sure that there are no persons, property and/or
animals within one meter of the lift - vehicle included
- before raising the lift.
Fig. 7: PONYBENCH BPPLUS CONTROL CONSOLE
�
4.2.4 LOWERING THE PONYBENCH BPPLUS
LIFT
��
The descent of the lift occurs as follows (fi g. 7):
�
• DESCENT TO FIRST SECTION.
• COMPLETE DESCENT
�
Descent to the fi rst section
�
WARNING! Before lowering the lift, make sure
that there are no persons, animals orproperty
that may remain trapped or crushed below if
the vehicle falls.
WARNING! The base of the lift to which the fall-
proof safety hook is attached mustalways be
free from all obstacle.
WARNING! Before lowering the lift, always
make sure that there are no pipes or powertool
cables in the vicinity that may be crushed.
Proceed as follows for <descent to the fi rst section>:
• Rotate the <ascent> selector (2) and keep it pressed
until the fall-proofsafety hook is released.
• Rotate the <descent> selector (1) counter-clockwise,
and the movableplatform will descend. Keep the
selector (1) rotated until the PONYBENCH BPPLUS
automatically stops at a height of 30-35 cm by
thetriggering of the stroke-end safety microswitch.
76
PUSHBUTTON PANEL