spanesi PONYBENCH BPPLUS Manuel D'utilisation Et De Maintenance page 77

Complete descent
WARNING! Before continuing descent all the
way to the ground, make sure that there are no
persons, animals or property that may remain
trapped or crushed below if the vehicle falls.
WARNING! The base of the lift to which the fall-
proof safety hook is attached must always be
free from all obstacle.
WARNING! Before lowering the lift, always
make sure that there are no pipes or powertool
cables in the vicinity that may be crushed.
Proceed as follows for in order to complete descent:
• Rotate the <descent> selector (1) clockwise: the
movable platform will continue descending (if the lift
is already at a height that is lower than the stroke-end
microswitch intervention height, rotate the <ascent>
selector (2) clockwise).
• Keep the selector (1) rotated until the rubber vehicle
support buffers are released from the weight of the
vehicle and that the weight of the vehicle is no longer
supported by the lift (and the vehicle rests on the
ground).
• Remove the rubber vehicle support buffers from the
lifting arms. Rotate the selector (3) counter-clockwise
until the lifting arms return into themovable platform.
Rotate the <descent> selector (1) clockwise once
again until the movable platform disappears into the
pit.
• Keep the selector (1) rotated clockwise until the
PONYBENCH BPPLUS movable platform is stopped
at the end of its descent stroke at the level of the
fl oor.
Fig. 7: PONYBENCH BPPLUS CONTROL CONSOLE
�
��
�
�
�
77
PUSHBUTTON PANEL
GB