EUROM EK2K Manuel D'utilisation page 27

fallen or shows any other signs of damage. Remove the plug from
the socket immediately. Take the entire device back to your
supplier or a recognised electrician to be checked and/or repaired.
Always ask for original parts to be used.
4. The device may only be opened and/or repaired by a competent
and qualified person. Do not carry our your own repairs as this
could be dangerous! Repairs carried out by unauthorised persons or
changes made to the device could damage the dust/waterproof
capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences.
Description
1. House
2. Handle
3. Outlet grill hot air
4. Electrical cable with plug
5. Operation panel (Back side)
6. Control switch
7. Thermostat dial
Inside: PTC-element and fan
Location and Connection
 Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
 Make sure the heater is switched off (switch to O position), then plug into a
correctly functioning 230V-50Hz socket. Only connect the heater to an earthed
socket!
27