Güde AP 180-1150 E Traduction Du Mode D'emploi D'origine page 14

ENGLISH
10
Technical Data
Polisher
Art. No
Service connection
Rated input
No-load speed
Polishing disk diameter
Thread of work spindle
Weight
Noise details
Sound pressure level L
Sound power level L
Measured according to EN 60745; Uncertainty K =
3 dB (A)
Wear ear protectors!
Vibration details
Vibration total values (triaxial vector sum) deter-
mined according to EN 60745:
Polishing: Vibration emission
value a
h
Uncertainty K = 1,5 m/s
WARNING: The vibration emission level will vary
because of the ways in which a power tool can be
used and may increase above the level given in this
information sheet.
The vibration emission level may be used to compare
one tool with another.
It may be used for a preliminary assessment of
exposure.
An accurate estimate of the vibratory load
should also take into account the times when the
tool is shut down or when it is running but not
actually in use. This may significantly reduce the
vibratory load over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
control elements and how to use the appliance
properly. Abide by all the safety measures stated in
the service manual. Act responsibly toward third
parties.
The operator is responsible for accidents or risks to
third parties.
AP 180-1150 E
230 V ~ 50 Hz
800 – 3000 min
88,3 dB(A)
pA
99,3 dB(A)
WA
2
Read and understand the operating
instructions before using the
appliance. Familiarise with the
Persons over 16 years of age can only work on the
appliance. An exception includes youngsters trained
in order to reach knowledge under supervision
of the trainer during occupational education.
In case of any doubts about connection and operati-
58110
on refer please to our customer center
1150 W
Specified Conditions Of Use
-1 The polisher can be used for polishing lacquers,
coatings, plastics and other smooth surfaces.
180 mm
Use only commercially available polishes.
M14
The surface has to be dry, and free from dust and
2,05 kg
grease. Dirt on the surface to be machined or to the
sanding pad does not make the manufacturer liable
for surface damages.
Please refer to the instructions supplied by the acces-
sory manufacturer.
The machine is suitable only for working without
water.
Do not use this product in any other way as stated for
normal use. Not observing general regulations in force
and instructions from this manual does not make the
manufacturer liable for damages.
Emergency procedure
9,08 m/s²
Conduct a first-aid procedure adequate to the injury
and summon qualified medical attendance as quickly
as possible. Protect the injured person from further
harm and calm them down. If you seek help, state the
following pieces of information: 1. Accident site, 2.
Accident type, 3. Number of injured persons, 4. Injury
type(s)
Symbols
WARNING / Caution!
Read the operating instructions to reduce
the risk of injury.
Wear eye protective goggles !
Wear ear protectors!
Wear gloves!
Unplug the machine before any work
on it.
Class II tool.
CE marking