Plum Summit Mode D'emploi page 41

HOW TO STEP IN WALK MODE?
Make sure the toe part clamp (1) is open. If closed, push the locker (3) down,
until the toe part clamp opens.
Make sure the heelpieces are in one of the two uphill positions.
Check nothing is present under the toe piece or the ski and clean any foreign
material from your boot sole.
Find out which out the four following methods suits you:
- Method 1: place the toe of your boot over toe piece, keeping the heel a little
bit elevated, pushing down until the two front pins (1) fasten into the boot tip
insert (15).
- Method 2: place the toe of your boot over the toe piece, keeping the heel a
little bit elevated, and then rotate your boot in order to fit one of the front
inserts (1) in the boot tip insert (15). Then push boot down flat until the toe
piece fastens and both inserts (1) perfectly fit the boot tip inserts (15).
- Method 3: This method is a lot easier if you are equipped with Quick-Step
technology inserts. Place the toe of your boot onto the toe piece horizontally.
Then push down, until the toe piece fastens and both inserts (1) fit into the
boot tip inserts (15).
- Method 4: Make sure your heelpiece is in low position. Bring your boot heel
against the heelpiece keeping the tip a little bit elevated. Then push down onto
toe piece with the toe of the boot until the clamp fastens and both inserts (1)
fit perfectly in the boot tip inserts (15).
WARNING: When stepped in, pull up the locker (3) to place it in WALK mode.
Then tie on the safety leashes.
19 | P a g e
User Manual